Essex Electronics K1 Series Manual de Instruções descarregar pdf (Página 21)

Essex Electronics, Inc. | 805.684.7601 | 800.KEY-LESS | fax 805.684.0232 | keyless.com

The Master Code can be congured to activate either Relay #1 or

Relay #2 depending on how the system hardware is set up (see

Setting Relay Options on page 11). However, the Master Code

cannot be congured to Latch either relay.

 Programming the Master Code

To Program/Change the Master Code:

1. Select a 3 to 8 digit code that will be used for the Master Code.

___ ___ ___ ___ ___ ___ ___ ___

2. Locate the Control Module, remove the cover and locate the

“PROGRAM” switch on the circuit board.

3. Press the PROGRAM switch once *. (The Keypad will beep

rapidly 4 times)

4. At the Keypad, enter 1-1-1-9 to open the memory (you will hear

three rapid beeps) and immediately enter your new Master code.

(Do not let more than ve seconds elapse between entries or the

system will reset!!!)

5. After entering your new code, wait ve seconds for the 3 reset

beeps.

* Once the PROGRAM switch has been pressed, you have 2

minutes to begin programming.

 Overview of User Codes

There are a total of 5 User codes (also called Secondary Codes)

that can be programmed into the KE-265. User Codes can vary in

length from 3 to 8 digits. Each User Code is programmed into one.

of 5 User Locations. These Locations are as follows:

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Sem comentários

Essex Electronics K1 Series Manual de Instruções Página 21